Gen 1 Raptor

All of our products are made 100% in house, designed in CAD and then CNC cut on our Torchmate plasma table, they are then hand bent, welded, and smoothed.  This is our Direct Bolt On, No Drill Chase Rack, it mounts to factory tie down positions...

GEN 1 RAPTOR BED CAGE WITH LONG TRAVEL SHOCK MOUNTS All of our products are made 100% in house, designed in CAD and then CNC cut on our Torchmate plasma table, they are then hand bent, welded, and smoothed.   KHC engineered and built this Gen...

Rod End Protective Rubber Dust Boot 3/4 Inch to 7/8 Inch Heim Fits FK Bearing, Aurora Bearing Or NHB These trick rubber boots keep dust, water and other contaminants out of those expensive heim joints, giving them a longer lifespan. Comes in a set of...

Type a description for this product here...

The latest Update of the KHC Under The Cover Tire Carrier  -Now clears up to a 39in tire -No drilling required  -bolts into factory bed holes -Jack Mount Add on avalible for extra cost  WE CAN NOW MAKE THESE FOR ANY TRUCK CONTACT US...

Fresh off the table, and set at a introductory price of $60 + shipping   Reduce the risk of cracked leaf springs on your F150 and Gen 1 and 2 Raptor.s This kit includes two black powder coated plates and install very easily. Will work with factory...

KHC built and designed double adjustable upper control arm for the F150 Raptor.  Built from 3/16th steel. 1.25 Uniball 7/8th FK Rod Ends Fully Adjustable ends without removal. Fits Raptors with stock wheels  PACKAGE DEAL  Pair this...

I finished up the updates on the Lower Control Arm pocket support system. I have fixed more than a few bent LCA pockets which is what inspired this kit. The rear pockets are very prone to bending on both gen1 and gen2 due to lack of support on the back...

This custom in house designed bump-stop brace kit is made from 1/4 inch steel and is designed to brace the rear frame of your F150 Raptor in order to prevent frame twist from hard bottoming out. The stock bump-stop location on your Raptor are mounted...

Type a description for this product here...

KHC's Gen 1 Raptor custom tubular front bumper, this is a frame cut bumper for Gen 1 Raptors (10-14) and are made to order. 

 Run these with +2 or +3 leafs on your F150/Raptor platforms to maximize travel by lowering the rear of the truck after new leaf install and replacing the weaker stock shackles $249 plus shipping and come powdercoated 

KHC built and designed adjustable upper control arm for the F150 Raptor.  Built from 3/16th steel. 1.25 Uniball 7/8th FK Rod Ends Fully Adjustable ends without removal. Fits Raptors with stock wheels  PACKAGE DEAL  Pair this with...

Made from 1/4 aluminum. Mounts to factory rear cargo tie downs, pass or driver side. Uses quickfist clamps or clamps of your choosing. (not included) Fits 09-14 F150/Raptor.

This is our Low Profile Chase Rack for Gen 1 and Gen 2 Raptors this rack can fit a 30in light bar and 2 Pods next to it. Doesn't Block Rear Brake Light it is a low profile design so the entire rack is flush with the bottom of the 3rd brake light...

Here are our Gen 1 Lower Control Arm support kit for 2010-2014 SVT Raptors. This kit not only strengthens your lower control arm pockets for heavier loads and hard impacts from off-roading but also locks out your lower control arms which helps keep your...